Troubleshooting; Maintenance; Failure To Start - Porter Cable 7812 Manual De Instrucciones

Always remove paper bag before picking up liquids or wet material. The vacuum
motor will shut off automatically when the container is full. Turn the vacuum
cleaner "OFF" before emptying container.
Disconnect appliance from power circuit before removing
power unit from container.
The Model 7814 has a drain hose located at the rear of the container. Remove the
hose from its holder and point it downward to drain the container (see Fig. 9).
Always clean and dry the interior of the container after using the machine for wet
pick-up. Also clean the two brass colored electrodes (see A, Fig. 10), on the
bottom of the motor unit. These electrodes are part of the low-voltage system
that stops the vacuum motor when the container is full of liquid or wet material.
FIG. 9
For assistance with your tool, visit our website at www.deltaportercable.com for a list of
service centers, or call the PORTER-CABLE Customer Care Center at (888) 848-5175
To reduce the risk of injury, turn unit off and disconnect it from
power source before installing and removing accessories, before adjusting or
when making repairs. An accidental start-up can cause injury.
CLEANING
Blow dirt and dust out of all air vents with dry air at least once
a week. Wear proper ANSI Z87.1 (CAN/CSA Z94.3) eye protection and proper
NIOSH/OSHA/MSHA respiratory protection when performing this.
Never use solvents or other harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals may weaken the materials used in these
parts. Use a cloth dampened only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool into a liquid.

FAILURE TO START

Should your tool fail to start, check to make sure the prongs on the cord plug are
making good contact in the outlet. Also, check for blown fuses or open circuit breakers
in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the
life of the unit under normal operating conditions. No further lubrication is necessary.

TROUBLESHOOTING

MAINTENANCE

9- ENG 9- ENG
A
FIG. 10