Worx WX523 Manual Original página 19

TROUBLE SHOOTING
Symptom
Tool will not start when
operating the on/off switch.
Cutting depth is less than
that is set.
Blade spins or slips
Blade will not cut a straight
line.
Blade kicks back when
beginning a cut
20V Lithium-Ion Cordless Circular Saw
Possible Causes
Battery park not plugged
in.
Battery park is powered off.
Carbon brush has worn
down
Sawdust accumulated at
the rear of the base.
Blade is not tightly
engaged with the spindle.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly.
Blade is not spinning fast
enough
Possible Solution
Check to make sure battery park
is connected well into a working
outlet
Charging the battery.
Replace the carbon brush using a
qualified maintenance person.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Remove the blade, and
reassemble it as described in
SAW BLADE ASSEMBLY AND
REMOVING section.
Mount a new, sharp blade on
the saw.
Check that blade is properly
mounted.
Use a parallel guide.
Allow the saw blade to reach full
speed prior to beginning a cut in
the material.
19
EN