Pre-Start Inspection Procedures - Mi-T-M Corporation LV Serie Manual De Instrucciones

INSTALLATION & PREPARATION

PRE-START INSPECTION PROCEDURES:

1. Before starting the unit, perform the following procedures:
a. Check the oil level in the pump (12) and engine (5).
b. Inspect the water inlet strainer (11).
Clean or replace if necessary.
See "Water Supply", #2, pg. 13.
c. Check all hose connections to ensure they are securely tightened.
See "Water Supply", #5, pg. 13.
d. Inspect for system fuel leaks.
If a fuel leak is found, DO NOT START UNIT!
See "Fire & Ventilation Precautions", #2 and #4, pg. 4.
Be sure that all damaged parts are replaced and that the
mechanical problems are corrected prior to operation of the unit.
If you require service, contact Customer Service.
e. Inspect high pressure hoses for kinking, cuts and leaks.
If a cut or leak is found, DO NOT USE HOSE!
Replace hose before starting unit.
See "Miscellaneous Safety Precautions" #6, pg. 6.
Be sure that all damaged parts are replaced and that the
mechanical problems are corrected prior to operation of the unit.
If you require service, contact Customer Service.
END OF PREPARATION INSTRUCTIONS
14 Long Life Vertical LV-Series Operator's Manual