Ryobi BCS618 Manual De Utilización página 5

GB
FR DE ES
SPECIFICATIONS
Battery Voltage
Pack
BPP-1815M 18 V
BPP-1817M 18 V
BPL-1820 18 V
BPL-1815 18 V
OPERATION
WARNING
Do not allow familiarity with products to make
you careless. Remember that a careless fraction
of a second is sufficient to inflict serious injury.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating products.
Failure to do so could result in objects being
thrown into your eyes, resulting in possible
serious injury.
WARNING
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the following purposes:
„ Charging and maintaining Ryobi One+ 18 V battery
packs at peak charge over time.
NOTE: Charger charges batteries one at a time, charger
does NOT charger mutliple batteries simultaniously.
CAUTION:
Charge in a well ventilated area. Do not block
charger vents. Keep them clear to allow proper
ventilation.
IT NL PT DK SE
Charger Battery
Input Capacity
220-240V, 1.5 Ah
50-60Hz,
AC only
220-240V, 1.7 Ah
50-60Hz,
AC only
220-240V, 2.4 Ah
50-60Hz,
AC only
220-240V, 1.4 Ah
50-60Hz,
AC only
FI NO RU PL CZ
English
CAUTION:
If at any point during the charging process none
of the LEDs are lit, remove the battery pack from
No. of
the charger to avoid damaging the product. DO
cell for
NOT insert another battery. Return the charger
battery
and battery to your nearest service center for
service or replacement.
15
BATTERY PROTECTION FEATURES
Ryobi One+ 18 V lithium-ion batteries are designed with
15
features that protect the lithium-ion cells and maximize
battery life.
If the tool stops during use, release the trigger to reset
10
and resume operation. If the tool still does not work, the
battery needs to be recharged.
5
NOTE: The LED charge indicator light will not work if the
battery protection feature has caused the battery pack
to stop powering the tool. When the battery pack resets
itself, the LED will again function.
CHARGING THE BATTERY PACK
Use only these Ryobi One+ 18 V battery packs with
this charger.
Battery packs for this tool are shipped in a low charge
condition to prevent possible problems. Therefore,
you should charge them until the green LED on the front
of the charger comes on.
Note: The charger will also charge Ryobi One+ 18 V
Ni-Cd battery packs.
CHARGING A COOL BATTERY PACK
If the charger does not charge the battery pack under
normal circumstances, return both the battery pack and
charger to your nearest Authorized Service Center for
electrical check.
„ Charge the battery pack only with the charger
provided.
„ Make sure the power supply is normal household
voltage, 220V-240V, 50-60Hz, AC only.
„ Make sure the latches on each side of the battery
pack snap into place and the battery pack is secured
in the charger before beginning operation.
„ Connect the charger to the power supply.
„ Place the battery pack in the charger aligning raised
rib on the battery pack with the groove in the charger.
„ Press down on the battery pack to be sure contacts
on the battery pack engage properly with contacts in
the charger.
2
HU RO LV LT EE HR SI SK GR TR