Emerson PORTLAND CF965BS00 Manual Del Usuario página 21

9. Wall Control Installation
9.3
Before installing the SW605 wall control, place the SW605
wall control in "OFF" mode by pushing "ON/OFF" switch to
9.4
the "OFF" position.
Connect one black wire of the SW605 wall control to the
"hot" wire. Securely connect wires with wire connectors
9.5
supplied (Figure 33).
Connect one black wire of wall switch to the "load" (black)
wire in wall box. Securely connect wires with wire
connector supplied.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
9.6
Screw the SW605 wall control into wall box using the
supplied screws. Leave the SW605 wall control in "OFF"
mode until fan installation is completed.
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
9.7
The SW605 wall control is supplied with a white, ivory, and
almond color switch covers. Choose the finish that best
suits your needs and snap the cover onto the SW605 wall
9.8
control (Figure 33).
Install decorator wall plate using the two screws provided
with wall plate. Leave the SW605 wall control in "OFF"
mode until fan installation is completed (Figure 33).
(Continued)
SCREWS (2)
DECORATIVE WALL PLATE
Figure 33
Please contact 1-800-654-3545 for further assistance
21
SW605 FAN/LIGHT
WALL CONTROL
U
T
NEUTRAL
SWITCH COVER
WIRES
emersonfans.com
ETL Model No.: CF965
WALL
BOX