Problems - De Dietrich DPV7550B Manual Del Usuario

4
•

PROBLEMS

Before calling the technical service,
perform the verifications specified below
The appliance does not work:
Ensure that the power cable is plugged
in.
The pot sticks to the glass:
If there is molten material between the
pot and the glass, set the hot plate to
maximum power and try to separate
them.
Error F1
If any of the sensors is active more than
10 seconds, this error situation occurs
and error code"F1" is showed. This error
can be related with different roots. One
of them is that there may be an object
(fork, knife...) on the any of the sensor.
Make sure that there is no any object on
the control unit, hob glass is wiped with
a dry cloth. If error situation continue
after this solution, please take out plug
or switch off fuse switch for 10 second.
Error F2
If more than 2 sensors are sensed at
same time, this error situation occurs
and error code"F2" is displayed.
Potential root reasons of the problem :
• There may be an object(pot...) or
water accumulation(overflow liquid from
pot...) that cover more than 2 sensors
• Touch control location may exposure
more heat or steam (from oven bottom
of the hob...)
Please be sure that there is no any object
on the sensors and switched off all steam
and heat sources. Then,hob glass is wiped
with a dry cloth. If error situation continue
after this solution, please take out plug or
switch off fuse switch for 10 second.
Error FC
Fc message on the control and the hot
plates switch off: Overheating in the
electronics. Let thestove cool for a while.
32