Troubleshooting - Silverline 549095 Traducción Del Manual Original

GB
• Do not allow the machine to become wet
• Do not use any solvents or abrasive cleaners
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of electrical equipment that is no longer
functional and not viable for repair.
• Do not dispose of waste electrical and electronic equipment (WEEE) with household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
electrical equipment

Troubleshooting

Problem
Fuse (7) has blown
Discharged battery not charging
Discharged battery charging at a
slow rate
Battery water level has reduced and
there is bubbling and gassing of
the water
8
Possible cause
Black Negative Clamp (8) & Red Positive Clamp (9) have
touched
Black Negative Clamp (8) & Red Positive Clamp (9) are reversed
Battery internal fault
Poor connection
Battery sulphated
Fuse has blown
12V battery but set to 6V output
Battery at low temperature
Battery is being excessively over-charged
Charger left in Fast Charge mode
6V battery is being charged at 12V
Solution
Replace Fuse and ensure clamps are kept apart
Replace Fuse and ensure clamps are fitted to the correct terminals of the battery
Replace Fuse and battery
Check Black Negative Clamp (8) & Red Positive Clamp (9) are firmly
battery terminals. Clean terminals if necessary
Consult vehicle battery specialist to de-sulphate battery or replace battery
Replace Fuse
Use correct voltage setting
Charge rate will increase as battery warms
Disconnect battery charger from the mains supply immediately and ensure area is fully
ventilated. Do not smoke or allow open flames near battery. Top up battery with distilled
water (follow battery manufacturer instructions) and carefully check if battery is still in
serviceable condition
connected to