in order that the device can be re-packaged properly in
the event of a guarantee claim.
Setup location requirements
In order to ensure the safe and trouble-free operation
of the device, the setup location must
fulfil the follow ing
prerequisites:
-
Place the device on a firm, flat, level and heat-resistant
surface with sufficient loadbearing capacity for the
device and its contents.
-
Choose the setup location in such a way that children
cannot reach any hot surfaces on the device.
-
The device is not intended to be installed in a wall or a
built-in cupboard.
-
Do not set up the device in a hot, wet or extremely
damp environment or near flammable material.
-
Do not place the device near a gas or electric cooker or
an oven.
-
The device requires an adequate flow of air in order to
operate correctly. Leave a clearance of 20 cm all
around the device.
-
Do not cover up any openings on the device and do not
block these off.
-
The electrical socket must be easily accessible so that
the power lead can be disconnected easily, in the case
of an emergency .
-
The device and power cord should not come in contact
with the hot surface. The device could be damaged.
-
The installation and assembly of this device in non-
stationary setup locations must be carried out by
specialist companies/ electricians, provided they
guarantee the prerequisites for the safe use of this
device.