Setup - Velleman VM118R Manual Del Usario

Setup

SETUP
Hold 'shift' until the LED lights to enter the 'set-up' mode.
Choose one of the following options by pressing the corresponding button :
(1) 'Toggle'/'pulse'-selection.
(2) Display the current remote control address
(3) Change remote/relay card address
(4) Force remote/relay card address to address 1
(1) 'Toggle'/'pulse'-selection (LED flashes once) :
Allows you to select 'toggle' or 'pulse'mode for each channel.
Pressing a channel button (1..8) repeatedly allows you to choose between 'toggle'- and 'pulse'-mode for that particular
channel (LED flashes once : pulse, two flashes : toggle).
Press 'shift' to leave this mode. Press 'shift' again to leave set-up mode.
(2) Display the current remote control address on the K8056/VM118 relay card (LED flashes twice) :
Relay LEDs display the address in binary fashion i.e. LD8 : LSB, LD1 : MSB
Press 'shift' to leave the set-up mode.
(3) Change the current address of the remote and relay card (available addresses : 1..8) (LED flashes three times) :
Press button 1..8 to change the current address of the remote and the relay card.
The relay card will display the current address in binary fashion (see (2)).
Attention : All active cards will respond to this command (except when the 'remote control' jumper on the relay card is set to
'off'). Press 'shift' to leave this mode. Press 'shift' again to leave the set-up mode.
6