Technical Data - 3M PELTOR SportTac MT16H210F Serie Manual Del Usuario

ear-muffs.
• This ear-muff is provided with level-dependent attenuation. The wearer should check
correct operation before use. If distortion or failure is detected, the wearer should refer to the
manufacturer´s advice for maintenance and replacement of the battery.
• This ear-muff is provided with electrical audio input. The wearer should check correct
operation before use. If distortion or failure is detected, the wearer should refer to the
manufacturer's advice.
• Follow the advice in this manual on maintaining and replacing batteries.
• Performance may deteriorate with battery usage. The typical period of continuous use that
can be expected from the ear-muff battery is 600 hours.
• The output of the level-dependent circuit of this hearing protector may exceed the external
sound level.
• The output of the electrical audio circuit of this hearing protector may exceed the daily limit
sound level.
5. MAINTENANCE
5:1 Replacing the ear cushions
(C:1) Slide your fingers under the edge of the ear cushion and pull straight out.
(C:2) Insert the new foam and ear cushion
(C:3) Press until it snaps into place.
5:2 Cleaning
Remove the ear cushions and attenuation cushions (Fig. C) if you have been wearing the
product for a long time or if moisture has gathered inside the cups. Clean and disinfect the
cups, headband and ear cushions regularly with soap and warm water. Make sure the soap
is known not to be harmful to the wearer. Allow the product to dry before you use it again. Do
not immerse the product in water!
5:3 Use and Storage
Remove the batteries when storing the product. Do not store the hearing protector at tem-
peratures above +55°C, (for example on a dashboard, a parcel shelf or a window sill), or at
temperatures below –40°C. Do not use the hearing protector at temperatures above +55°C,
or below –20°C.
5:4 WEEE (Waste Electrical and Electronic Equipment) Symbol
Below requirement applies in the European Union.
Do NOT dispose your product as unsorted municipal waste!
The crossed-out wheeled-bin symbol indicates that all EEE (Electrical and Electronic Equip-
ment), batteries and accumulators must be disposed of according to local law by the use of
available return and collection systems.

6. TECHNICAL DATA

6:1 Standards and Approvals
3M Svenska AB hereby declares that 3M PELTOR SportTac, is in compliance with the es-
sential requirements and other relevant provisions of the PPE directive 89/686/EEC, the EMC
directive 2004/108/EC and the RoHS directive 2011/65/EU. Thereby they fulfil the require-
ments for CE marking. A copy of the declaration of conformity can be obtained by contacting
3M in the country of purchase. For contact information, see last pages of this user instruction.
The product has been tested and approved in accordance with EN 352-1:2002, EN352-
4:2001, EN 352-6:2002, EN 5022:2010 +AC:2011 Class B, EN 55024:2010, EN61000-6-
2:2005 +AC:2005, EN 61000-6-3:2007 +A1:2011 and EN 50581:2012.
The product has been examined by:
DECTRON AB, Thörnblads väg 6, SE-386 90 Färjestaden, Sweden
INSPEC International Ltd, 56 Leslie Hough Way, Salford, Greater Manchester, M6 6AJ,
United Kingdom Notified Body #0194.
6:2 Explanation of the attenuation data (Table D)
1. Frequency (Hz)
2. Mean attenuation (dB)
3. Standard deviation (dB)
4. Assumed Protection Value, APV
5. Weight (g)
6:3 Explanation of the table electrical audio input level (Table E)
1. Model designation
2. Input signal level U (mV, RMS)
3. Mean Sound Pressure Level (dB(A))
2
GB