GE PSB42 Manual Del Propietario E Instrucciones De Instalación página 21

STEP 4 INSTALLATION WITH
HOUSEHOLD WATER
FILTRATION SYSTEM
Skip this step if you do not have a household water
filtration system
household water filtration system, the filter cartridge
performance, remove the filter and install the filter
bypass plug.
Rotate Counterclockwise
To Remove
STEP 5 INSTALL SIDE PANELS
Skip this step when not using side panels.
refrigerator with stick-on hook and loop fastener strips
before setting the refrigerator in place.
STEP 6 ANIT-TIP PROCEDURE
WARNING
These refrigerators are top heavy, especially
with any doors open, and must be secured to
prevent tipping forward which could result in
death or serious injury. Read and follow the
entire installation instructions for securing the
refrigerator with the anti-tip system.
the block to the
mounting brackets
provided using #12
or #14 wood screws.
• Secure the bracket
with wood block to
the back wall so that
#12 or #14 wood screws. See the illustration.
49-60742-4
Installation Instructions
Plug
Tip Over Hazard.
STEP 6 ANIT-TIP PROCEDURE
(Cont.)
• The screws must penetrate at least one inch into
the vertical wall studs.
screws in place of wood screws.
IMPORTANT: When the refrigerator is installed
under a soffit or if there is not enough height for
this method of security, brackets cannot be used.
Proceed to step 7 to level the refrigerator and then
to step 8 to secure refrigerator to cabinets.
refrigerator must be secured to prevent tipping.
Connect power cord:
• Before pushing the refrigerator into the opening,
plug the power cord into the receptacle. Open the
grille panel and reach into the opening at the back
to grasp the power cord. Pull the power cord into
the opening as you push the refrigerator back.
• Gently push refrigerator into the opening with hands
against front corners.
The
21