GE PSB42 Manual Del Propietario E Instrucciones De Instalación página 23

STEP 10 CONNECT WATER
SUPPLY
Refrigerator
Water Suppl
cabinet.
• Turn the water on to flush debris from the line. Run
about a quart of water through the tubing into a
bucket, then shut off the water.
Copper Tubing:
fitting on the unit and tighten the nut to the union.
• Turn on the water to check for leaks.
SmartConnect ™ Tubing:
NOTE: The only GE Appliances-approved plastic
tubing is supplied in the SmartConnect Refrigerator
line because the line is under pressure at all times.
Other types of plastic may crack or rupture with age
and cause water damage to your home.
SmartConnect
in the following lengths:
refrigerator connection. Tighten the compression nut
until it is just hand tight.
• Tighten one additional turn with a wrench.
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with the toekick installation.
49-60742-4
Installation Instructions
House
Water Suppl
STEP 11 CONNECT POWER,
CLOSE GRILLE PANEL
• Open the grille panel.
is too tight, remove the 2 screws holding the water
filter bracket and move aside. Plug in the power cord
and secure the bracket with the original screws.
Bracket
Screws
Master Light
Switches
• Check to make sure power to refrigerator is on by
opening refrigerator door to see if interior lights are
on.
adjustments.
STEP 12 START ICEMAKER
Power
Switch
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the
feeler arm.
Electrical
Outlet Access
23