Kohler Sterling 950C Serie Guia De Instalacion página 6

Bottom Track Lip
Toward Outside
Caulk here.
3. Locate the Bottom Track
Locate the bottom track on the flattest part of the shower ledge. The leg of the track should face
toward the outside edge of the shower ledge.
IMPORTANT! The bottom track must sit flat on the shower ledge. If the ledge has a curve in the corners
at the sidewalls, it may be necessary to shape the ends of the track with a file.
Make sure the bottom track is placed so it is an equal distance from the front edge of the shower
ledge at all points.
Mark the location of the bottom track with a soft pencil.
Remove the bottom track and apply a bead of silicone sealant on the underside of the track, as
shown.
Reinstall the bottom track at the marked location.
Temporarily secure the bottom track to the ledge with masking tape, taking care to keep the track in
the desired position.
4. Install the Adjustment Clamps
Insert the adjustment clamp into the wall jamb.
Align the hole in the adjustment clamp with the hole in the wall jamb.
Fasten the adjustment clamp to the wall jamb with a #8-18 x 1/2" panhead screw. Do not tighten the
screw.
Repeat with the other two holes in the wall jamb.
Repeat the procedures with the second wall jamb.
1034023-2-D
#8-18 x 1/2"
Panhead Screw
Correct Installation of
Adjustment Clamp
6
Adjustment
Clamp
Wall Jamb
(Outside)
Sterling