Kohler Sterling 950C Serie Guia De Instalacion página 11

Subtract 1/8" (3 mm)
From Measurement
Strike
Jamb
Top View
Swing open
toward left
Subtract 1/8" (3 mm)
From Measurement
Hinge
Jamb
12. Measure and Cut the Drip Rail
Measure from the edge of the strike jamb to the edge of the hinge jamb.
Subtract 1/8" (3 mm) from the measured distance and cut the drip rail to that measurement.
File the rough edges until they are smooth.
13. Install the Flat Seal
IMPORTANT! If the seal is misshapen when taken out of the packaging, immerse it in warm water until
it regains its proper shape.
NOTE: Water or petroleum jelly may help when sliding the seal in place.
Slide the seal into the groove in the drip rail.
Cut the seal to the same length as the drip rail.
Crimp each end of the drip rail with pliers to hold the seal in place.
Sterling
Top View
Swing open
toward right
Hinge
Jamb
Strike
Jamb
Double
Face Tape
Crimp each
end of drip rail.
11
Drip Rail
Seal
Drip Rail
Seal
Installed
1034023-2-D