Kohler Sterling 950C Serie Guia De Instalacion página 5

Swing open toward right
Swing open toward left
1. Determine the Door Configuration
IMPORTANT! Install the pivot side of the door on the side opposite the showerhead.
Determine whether the door will pivot on the right or left side.
Make sure the door can swing freely in the chosen configuration.
2. Measure and Cut the Bottom Track
IMPORTANT! Risk of product damage. If your shower has a curve in the corners where they meet the
sidewalls, be sure to measure from wall to wall above the curves. Failure to measure above the curve or
angle could result in the bottom track being cut too short.
CAUTION: Risk of product damage. Do not cut the header at this time. The header dimension is
not the same as the bottom track dimension.
Measure from wall to wall at the flattest part of the shower ledge (Distance D).
Subtract 1/16" (2 mm) from dimension "D." The resulting dimension is the bottom track cut length.
NOTE: For best results use a miter box and 32-teeth per inch hacksaw to make the cut.
Cut the bottom track at the mark.
File the rough edges smooth where the bottom track was cut, taking care to avoid damaging
finished surfaces.
Sterling
Top View
Top View
Measure
here.
Measure distance "D"
above curves in the
corners.
Angled
Base
Important: Measure carefully. If your walls are
curved or angled, measure above the curve or
angle. Failure to do so can result in an improperly
cut bottom track.
5
Measure
here.
Curved
Base
D
1034023-2-D