Key Usage Tips; Aqualift ® Self-Cleaning Technology; Surface Temperatures; Preheating - Whirlpool WFE775H0HV Instrucciones Para El Usuario

AquaLift Self-Cleaning Technology
®
AquaLift Self-Cleaning Technology is a first-of-its-kind cleaning
®
solution designed to minimize the time, temperature, and odors
that ordinarily come with traditional self-cleaning methods. With
AquaLift Self-Cleaning Technology, an innovative coating on the
®
interior of the oven is activated with heat and water to release
baked-on soil. To use AquaLift
wipe out loose debris, pour water into the oven bottom, and run
the AquaLift Self-Cleaning cycle. When the cycle finishes in
®
under 1 hour at a lower temperature than traditional self-cleaning
methods, just wipe out the remaining water and loose debris.
See the "Clean Cycle" section for more detailed instructions. For
additional information, frequently asked questions and videos
on using AquaLift Self-Cleaning Technology, visit our website at
®
http://whirlpoolcorp.com/aqualift.

Surface Temperatures

When the range is in use, all range surfaces may become hot,
such as the knobs and oven door.
Warming or Storage Drawer
When the oven is in use, the drawer may become hot. Do not store
plastics, cloth, or other items that could melt or burn in the drawer.
Oven Vent
The oven vent releases hot air and moisture from the oven and
should not be blocked or covered. Do not set plastics, paper,
or other items that could melt or burn near the oven vent.

Preheating

When beginning a Bake or Convect cycle, the oven will begin
preheating after the Start keypad is pressed. The oven will take
approximately 12 to 15 minutes to reach 350°F (177°C) with all
of the oven racks provided with your oven inside the oven cavity.
Higher temperatures will take longer to preheat. The preheat
cycle rapidly increases the oven temperature. The actual oven
temperature will go above your set temperature to offset the heat
lost when your oven door is opened to insert food. This ensures
that when you place your food in the oven, the oven will begin at
the proper temperature. Insert your food when the preheat tone
sounds. Do not open the door during preheat before the tone
sounds.
4

KEY USAGE TIPS

Self-Cleaning Technology, simply
®

Ceramic Glass Cooktop Cleaning

To avoid damaging the cooktop, do not use steel wool, abrasive
powder cleansers, chlorine bleach, rust remover, or ammonia.
1. Remove food/residue with the Cooktop Scraper.
For best results, use the Cooktop Scraper while the
■
cooktop is still warm but not hot to the touch. It is
recommended to wear an oven mitt while scraping
the warm cooktop.
Hold the Cooktop Scraper at approximately a 45° angle
■
against the glass surface and scrape the residue. It will
be necessary to apply pressure in order to remove the
residue.
Allow the cooktop to cool down completely before proceeding
to Step 2.
2. Apply a few dime-sized drops of affresh
to the affected areas.
Rub affresh Cooktop Cleaner onto the cooktop surface
®
■
with the blue Cooktop Cleaning Pad. Some pressure is
needed to remove stubborn stains.
Allow the cleaner to dry to a white haze before proceeding
■
to Step 3.
3. Polish with a clean, dry cloth or a clean, dry paper towel.
Repeat steps 1 through 3 as necessary for stubborn
■
or burned-on stains.
The Complete Cooktop Cleaner Kit is available for order and
includes the following:
Cooktop Scraper
■
affresh Cooktop Cleaner
®
■
Blue Cooktop Cleaning Pads
■
See the "Accessories" section for part numbers and information
on ordering.
Cooktop Cleaner
®