Troubleshooting - Whirlpool WFE775H0HV Instrucciones Para El Usuario

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid
a service call, refer to the warranty page in these instructions, or visit producthelp.www.whirlpool.com. In Canada, visit
www.whirlpool.ca
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Problem Possible Causes and/or Solutions
Nothing will operate Power supply cord is unplugged: Plug into a grounded outlet.
Household fuse is blown or a circuit breaker is tripped: Replace the fuse or reset the circuit breaker. If the
problem continues, call an electrician.
The control displays an F9 or F9 E0 error code: The electrical outlet in the home may be miswired. Contact
a qualified electrician to verify the electrical supply.
Cooktop will not The control knob is not set correctly: Push in knob before turning to a setting.
operate
On ceramic glass models, the oven control lockout is set: See "Control Lock" in the "Feature Guide"
section.
Excessive heat Cookware is not the proper size: Use cookware about the same size as the surface cooking area, element,
around cookware or surface burner. Cookware should not extend more than 1/2" (13 mm) outside the cooking area.
on cooktop
Cooktop cooking Control knob set to incorrect heat level: See the "Cooktop" section.
results not
Range is not level: Level the range. See the Installation Instructions.
what expected
Cooktop element Element cycling due to a temperature limiter: This is normal operation. The element may cycle on and off to
cycles on and off keep the cooktop from overheating.
on Hi setting
Oven will not operate Delay Start is set: See the "Electronic Oven Controls" section.
Control lock is on: Press and hold CONTROL LOCK for 3 seconds to unlock.
Control is in Demo mode: Demo mode will deactivate all oven elements. See "Demo Mode" in the "Electronic
Oven Controls" section.
Electronic oven control set incorrectly: See the "Electronic Oven Controls" section.
Oven temperature Oven temperature needs adjustment: See "Oven Temperature Control" in the "Electronic
too high or too low Oven Controls" section.
Oven indicator Power to range is turned on or restored: See "Control Display" in the "Electronic Oven Controls" section. If
lights flash
the indicator lights keep flashing, call for service.
Display shows Power failure (display shows flashing time): Clear the display. On some models, reset the clock, if needed.
messages
See "Clock" keypad feature in the "Feature Guide" section.
Error code (display shows letter followed by number): Depending on your model, press the Cancel keypad
to clear the display. See "Control Display" in the "Electronic Oven Controls" section. If it reappears, call
for service.

TROUBLESHOOTING

In Canada:
Whirlpool Brand Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
17