Sony IPELA SNC-DF70N Manual De Instalación página 44

Insert the cables through the side
3
conduit hole, and connect the cables
to their respective connectors, and
secure them with the cable clamp.
Network cable: Connect to a
network port of this unit.
24 V AC/12 V DC (power input)
cable: Connect to an AC/DC IN
connector.
I/O cable: Connect to EXT CTRL
connector.
Audio cable: Connect to MIC/SP
connector.
Attach the plug that was removed
4
from the side conduit hole to the
bottom conduit hole.
Notes
• When you connect a pipe/plug to the
conduit hole, be sure to turn the pipe/
plug all the way and lock it in place.
Otherwise, moisture may leak into the
casing.
• When you insert the plug in the bottom
conduit hole, clean the thread grooves
of the bottom conduit hole and install
the plug securely.
• Cover the joint part of the pipe/plug
with silicon sealant, etc. to prevent
moisture from getting inside the
casing.
• Use a pipe/plug with a thread length of
12 mm or less so that it does not
damage the camera.
4
When installing on a ceiling or wall,
fix the supplied wire rope to the
bottom of the camera and the ceiling
(or wall).
Fix the wire rope to the ceiling or
1
wall.
Remove the screw on the bottom of
2
the camera, and string the screw
through the hole of the wire rope.
16
GB
Installing the Unit
12 mm or less
Then secure the screw firmly so that
it will not come loose.
Ceiling
5
Install the camera on the ceiling or
wall with the four supplied screws.
Notes
• Be sure to install the supplied wire rope to
the camera and the ceiling or wall.
• If the ceiling or wall material is not strong
enough to hold the screws, the camera may
fall off. Reinforce the ceiling or wall as
needed.
• If you cannot use screws on a ceiling or
wall, or if you want to hide the camera to
be less conspicuous, use the YT-ICB70 in-
ceiling bracket (optional) with which you
can mount the camera on the ceiling.
Wire rope