OPERATION
If you have thick hair, you might
7
have to repeat this procedure on
the same section several times.
5 After use, switch the appliance off
by pressing the On/Off button
for 2 seconds. The LCD
E
light turns off and the On/Off but-
ton lights up red. Then unplug the
power cord
C
Styling waves or
curls
1 Comb or brush out a section of
your hair about 3 cm wide, start-
ing at the neck.
2 Place the section of hair between
the plates
A
line as you can, and then close
them.
Caution
Do not touch the plates as they are
7
very hot.
3 Hold the appliance in position until
the hair is heated.
– This takes a few seconds at the
most.
4 Depending on the hair style, rotate
the appliance by 180° so that the
hair wraps around it at the height
of the heating plates
2 4 ENGLISH
_______________________
.
as close to the hair
.
A
5 While rotating, slowly pull the ap-
pliance towards the ends of the
hair.
– A curl is formed once the
appliance has been pulled
down and over the ends of the
B
hair.
Note
Repeat the procedure section by
7
section.
6 After use, switch the appliance
off by pressing the On/Off but-
ton
for 2 seconds. The LCD
E
light turns off and the On/Off but-
ton lights up red. Then unplug the
power cord
Notes
If the appliance is not used for a
7
while after it is heated up, it au-
tomatically switches off after 60
minutes.
Never leave the appliance unat-
7
tended while it is plugged in.
Unplug the power cord after use.
7
Place the appliance on a heat re-
7
sistant, safe and flat surface and
allow it to cool down.
.
C
B