Ordering Accessories - Philips 3100 Serie Manual Del Usario

English
26
Error Problem
code
01 The coffee funnel is
blocked by ground
coffee or a foreign
object.
03 The brew group is
dirty or not well-
greased.
04 The brew group is not
positioned correctly.
05 There is air in the
water circuit.
The AquaClean filter
was not prepared
properly before
installation or it is
clogged.
14 The machine is
overheated.

Ordering accessories

To clean and descale the machine, only use the Philips maintenance products. These
products can be purchased from your local retailer, from the authorized service centers or
online at www.philips.com/coffee-care.
Maintenance products and type numbers:
- Descaling solution CA6700
- AquaClean filter CA6903
- Brew group grease HD5061
- Coffee oil remover tablets CA6704
- Milk circuit cleaner CA6705
- Maintenance kit CA6707
Possible solution
Turn off the machine and unplug it. Remove the brew
group. Then open the lid of the pre-ground coffee
compartment. Insert the spoon handle and move it up
and down to make clogged ground coffee fal down (Fig.
28). If a foreign object is blocking the coffee funnel,
remove it. Visit www.philips.com/coffee-care for detailed
video instructions
Turn off the machine with the main switch. Rinse the brew
group with fresh water, let it air-dry and then lubricate it
(see 'Lubricating the brew group'). Consult chapter
'Cleaning the brew group' or visit
www.philips.com/coffee-care for detailed video
instructions. Then turn the machine on again.
Turn off the machine with the main switch. Remove the
brew group and reinsert it. Make sure that the brew group
is in the correct position before you insert it. Consult
chapter 'Handling the brew group' or visit
www.philips.com/coffee-care for detailed video
instructions. Then turn the machine on again.
Restart the machine by turning it off and on again with
the main switch. If this works, dispense 2-3 cups of hot
water. Descale the machine if you have not done so for a
longer period of time.
Remove the AquaClean filter and try again to brew a
coffee. If this works, make sure that the AquaClean filter is
prepared properly before you place it back (see
'Preparing the AquaClean filter for activation'). Put the
AquaClean filter back into the water tank. If this still does
not work, the filter is clogged and needs to be replaced.
Turn the machine off and turn it back on again after 30
minutes.