Maintenance; Emptying The Dust Cup; Cleaning The Filters - Shark Slim Upright NV200 Serie Manual De Instrucciones

MAINTENANCE

To keep your vacuum's
suction power optimal, follow
these instructions. Make
sure unit is off and cord is
unplugged.
WARNING: To reduce
the risk of shock and
unintended operation,
turn off power and
unplug unit before
servicing.
Hand wash only with
water to prevent
damage from cleaning
chemicals. Allow ALL
filters to dry completely
before replacing
them in the vacuum
to prevent liquid from
being drawn into
electric parts.
IMPORTANT: DO NOT
use soap when cleaning
the HEPA filter.
RECOMMENDED

EMPTYING THE DUST CUP

FILTER CLEANING
1
Press the Dust Cup
SCHEDULE:
Release button and lift
Pre-Motor Filter Kit
dust cup off the vacuum.
(Foam & Felt)
XFF450
Clean every month.
Post-Motor Filter
(HEPA)
XHF450
Clean every 9 months.
13
1-800-798-7398
STEP 1 STEP 2
2 Hold dust cup over a trash
bin and press the latch
on the bottom of the dust
cup to empty it.
STEP 3
FOAM
FILTER
FELT
FILTER

CLEANING THE FILTERS

1 Pre-Motor
3 Press top Dust Cup
(foam and felt):
Release latch to access
With the dust cup
dust screen and remove
built-up debris as required. removed, take out the
foam and felt filters and
rinse them with water.
Be sure to let all filters
air-dry completely before
reinstalling. Tap loose dirt
off filters between washes
as needed.
HEPA
2 Post-Motor (HEPA):
To access the HEPA filter,
remove the floor nozzle
by pressing the Nozzle
Release button on the
side of the vacuum. To
release the filter frame,
turn latch to the unlock
symbol. Press the tab on
the HEPA filter to remove,
then rinse the filter with
water. Be sure to let all
filters air-dry completely
before reinstalling.
14
s h a r kc l e a n . c o m