Removing The Mask - Philips RESPIRONICS Wisp SE Nasal Mask Manual De Instrucciones

Tabla de contenido

Publicidad

Putting on the Mask
2. Headgear tab or clip H: Disconnect one, or both b. Peel the headgear tabs away from the
headgear strap and pull through slot in the mask frame or if using the clip twist outward.
3. Headgear: Pull the headgear on over your head c.
4. Cushion: Place the cushion over your nose.
5. Headgear tab or clip: Thread tab through slot in the mask frame or press the clip against the
headgear slot to reattach d.
Adjusting the Mask
6. Headgear: Peel the headgear tabs away from the headgear straps then press tabs against the
headgear straps to reattach e.
Connect the side strap to the headgear tab located at the base of the crown strap.
Connect the bottom strap tab near the back of the headgear.
7. Headgear: Adjust the side straps evenly f.
8. Headgear: Adjust the bottom straps evenly g.
The mask should rest comfortably against your face h.
Using Tube Management (Optional)
You may position the tube over your head.
9. Slide the mask tubing F through the headgear crown loop J before attaching the flexible
tubing i.
Using the Mask
10. The removable female adapter E may be needed to connect the exhalation device to the mask.
11. Connect the flexible tubing (included with your CPAP or bi-level device) to the exhalation device.
12. Turn the therapy device on. Lie down. Breathe normally.
13. Assume different sleeping positions. Move around until comfortable. If there are any excessive air
leaks, make final adjustments. Some air leaking is normal.
Comfort Tips
‡ The most common mistake is overtightening the headgear. The headgear should fit loose and
comfortable. If your skin bulges around the mask or if you see red marks on your face, loosen the
headgear.
‡ Re-seat the mask by pulling it directly away from your face and gently setting it back into place.
‡ Adjust the side headgear straps to reduce leaks around your eyes.

Removing the Mask

Disconnect a bottom headgear clip. Slide the headgear forward over your head.
Disassembly
Removing the Standard Elbow and Tubing
1. Squeeze the quick release tabs B j.
2. Pull the standard elbow C away from the cushion A k.
Removing the Cushion
Push the cushion C backwards through the frame G l.
Removing the Headgear
1. Detach the headgear bottom clips from the frame or undo the bottom tabs and pull.
2. Undo the headgear top tabs and pull the straps through the frame.
Assembly
Reversible Fabric Frame
Choose the fabric that feels comfortable against your skin. That side will face inward toward the
cushion and headgear. The clear frame is not reversible.
3

Publicidad

Tabla de contenido
loading

Tabla de contenido