Drinkwell AVALON-UK-17 Manual De Funcionamiento página 10

4. Remove the Filter Housing from the Pump by lifting
straight up (fig. 10).
5. Open the Filter Housing and remove the
Charcoal Filter from inside. Set the Filter Housing
aside for cleaning.
6. Remove the Rubber Cap affixed to the raised
post by inserting a finger under the lip and pull
straight up to remove (fig. 11).
7. While securely holding the electrical power cord
and the bottom of the Bowl with both hands,
pour out the remaining water inside the Bowl
into a sink.
8. With the Inline Plug disconnected and water
removed, grab the Pump and lift straight up to
disengage the suction cups. Continue pulling the
Pump's electrical power cord up and out through the raised post in the center of the
Bowl. Once the Pump is completely removed from the Bowl, separate the Foam Filter
and set aside for proper cleaning.
9. Once the Pet Fountain is completely disassembled, you will have: the Bowl and Tower,
two rubber pieces, the Filter Housing, a Charcoal Filter, Foam Filter and the Pump.
10. Clean the Pet Fountain parts with soap and warm water. You can also place the Pet
Fountain in the dishwasher, but we strongly recommend hand washing the ceramic
Pet Fountains. Never place the pump in the dishwasher. See the "Pump
Maintenance" section of this Operating Guide for detailed instructions on how to
properly clean your Pump.
1 1. If you have trouble reaching certain spots or hard-to-reach corners, try using a cotton
swab or purchase the Drinkwell
Cleaning Kit, visit our website at www.petsafe.net to locate a retailer near you.
10
Cleaning Kit, a 3-Piece Brush kit. To purchase a
®
www.petsafe.net
fig. 10
fig. 11