Before First Use - Klarstein 10028491 Manual De Instrucciones

Before installation
Before connecting the wine cooler to the power source, let it stand upright for approximately 4 hours. This
will reduce the possibility of a malfunction in the cooling system from improper handling during transporta-
tion. Clean the interior surface with lukewarm water using a soft cloth (see Maintenance and Cleaning).
Installation
• This wine cooler is designed to be free standing only, and should not be recessed or built-in.
• Allow 5 inches of space between the back and sides of the wine cooler, which allows the proper air
ventilation. Adjust the feet to keep the wine cooler level. Locate the wine cooler away from direct sun-
light and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Ambient temperature below 5°C or above 32°C will
hinder the performance of this appliance.
• Depending on the location of the appliance, the direction of the door opens can be changed.
• This unit is not designed for use in a garage or any other outside installation.
• Avoid locating the wine cooler in moist areas.
• Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under any circum-
stances cut or remove the third (ground) prong from the power cord. Any questions concerning power
and/or grounding should be directed toward a certified electrician or an authorized service center.
• This unit is not designed to be installed in an RV or used with an inverter.
• After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit to cool down for 3-4
hours under before placing wine bottles or beverages in the appliance.
• Keep ventilation openings in the appliance enclosure, clear of obstruction.
Reversing the door swing of the device
This appliance has the capability of the door opening from either the left or right side. The unit is delivered
to you with the door opening from the left side. Should you desire to reverse the opening direction, please
call service for reversal instructions.
During first use
When you first switch on the appliance, the compressor will run continuously until the wine cooler reaches a
cool enough temperature. During this period of time, you should try not to open the door frequently or place
bottles inside of the appliance. If the unit is switched off or unplugged, you must allow at least 5 minutes
before restarting the appliance or reconnecting it to your mains supply.
15

Before first Use