After Each Use; Battery Removal - Remington MB6550 Manual Del Usuario

ENGLISH
C CARE FOR YOUR BEARD TRIMMER
• Your beard trimmer is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and
unit regularly.

, AFTER EACH USE

• Ensure the beard trimmer is switched off and disconnected from the mains
before cleaning.
• Brush the accumulated hair from the blades.
• To clean unit, wipe with a damp cloth and dry immediately.
• Do not submerge the clipper in water.
• Empty vacuum chamber and rinse under running tap.
, WASHABLE ATTACHMENT HEADS
• The washable attachment heads are designed to ensure easy maintenance
of your beard and grooming kit.
• Ensure each of the attachment heads are removed from the beard trimmer.
• Wash the heads under a running tap to remove any hair clippings. Do not
run the entire unit under the tap.
• Once dry, place desired attachment head on top of the unit.
, Note: Ensure the clipper is turned off when cleaning.

BATTERY REMOVAL

• The battery must be removed from the appliance before it is scrapped.
• The appliance must be disconnected from the supply mains when
removing the battery.
• Ensure that the clipper is discharged of all power and disconnected from
the mains.
• Lift or pry the top housing and remove the top housing.
• Unscrew the 2 screws located on the printed circuit board assembly.
• Lift or pry the clipper halves apart, exposing the battery chamber.
• Take out the battery and printed circuit board assembly from the battery
chamber.
• Cut the tabs on both ends of the battery and remove it from the printed
circuit board.
• The battery is to be disposed of safely.
7