CAME COMMERCIALI Serie Manual Del Usuario página 46

S40 series - ANTIPANIC BAR application on MOBILE DOORS
S40 series - ANTIPANIC BAR application on MOBILE DOORS
8
UNI5933
M12x25
E
F
MAM002
G
E - Screw the M12X25 coupling screw and retighten the hooking screw (if necessary). Insert the PM339A
upper section on the PM208 upper joint and screw on the socket head screws provided.
Correctly align to the section before screwing.
F - Insert the two P4116 hooking plates (to attach to carriages) to the PM339A upper section and insert the
closing spring latch to the PM228A lower section, temporarily placing it at 5-8 cm from the edge.Prepare
the P4117 contact caps, making a bridge over the lower one and connecting the 2x0.50 bipolar cable to
the upper one (for connection to the "closed doors" control circuit). Close the two sections with the two
caps and thread the cable through the upper section until it reaches the other end (next to the joint).
G - For doors mounted from the outside, mount the MAM002 finish sector with the screws provided.
** In case of doors with irregular dimensions (see table on page 3), insert the P4117 sliding wheel as
indicated on page 13.
- pg. 22 -
S40 series - ANTIPANIC BAR application on MOBILE DOORS
S40 series - ANTIPANIC BAR application on MOBILE DOORS S40 series - ANTIPANIC BAR application on MOBILE DOORS
4
PM208
P4116
PM339A
PM338A
-
+
TO MODIFY THE ACTION OF THE
SPRING LATCH, MOVE IT TOWARD THE
CENTRE OF THE SECTIONS
PM339A
P4117
1
3
2
SPRING LATCH