Power Connections - CAME COMMERCIALI Serie Manual Del Usuario

Remove the 1-2 contact bridge
1
CONNECTION SEQUENCE
The connection sequence creates a series of closed contacts with the doors in normal sliding
operating position. Breaking through either door will cause the opening of the series, immediately
arresting the sliding movement.
1 - remove the "total stop" bridge from terminals 1-2
2 - connect the terminals in the connection terminal board to the spiral cables.
3 - connect the spiral cables from the terminal board to the carriage terminals and from these to
the upper contact cap
4 - connect the contacts of the lower contact cap.
Checks
- Check that the caps' contacts are aligned in the reinforced door position.
- Check the conduction of the connection heads to terminals 1-2 with an ohm tester.
Note: If the antipanic system and an automatic (CORSA or RODEO) door are ordered together,
part of the connections described and the application of the spiral cables will have already been
done.The installer will only need to connect the magnetic contacts and the mobile doors.
The data contained in this booklet is indicative. Came Cancelli Automatici S.p.A. reserves the right to make changes according to the product's
A T
SSISTENZA ECNICA
N V
UMERO ERDE
800 295830
W
EB
www.came.it
E-
MAIL
info@came.it
CANCELLI AUTOMATICI
CAME CANCELLI AUTOMATICI S.P.A.
D C (TREVISO)
OSSON DI ASIER
(+39) 0422 4940 (+39) 0422 4941

Power connections

Power connections
Power connections Power connections Power connections
Spiral cables
3
Contact caps
Contact bridge
4
technological evolution.
SISTEMA QUALITÀ
CERTIFICATO
CONTROL BOARD
1,6 A
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8 9 10 1 2 3 4
2
3
Contact bridge
4