Cleaning The Burner; Drain Extension Installation - Angelo Po 0N0GRG Manual De Uso

To carry out this operation, proceed as follows.
Remove the plate, the splashguard frame and
1)
the grid clearance reduction (see pages 10-11).
Lift and remove the burner (A).
2)
Clean the burner (A) and check that its holes
3)
are not blocked.
Caution - Warning
Take care never to pour water or allow dirt to
fall into the burner as this will cause the bur-
ner to malfunction.
Clean the interior of the device and drain all
4)
residue into the drip tray .
Caution - Warning
Check that the burner (B) bushing (A) is not
blocked.
Undo the screws (C), remove the drip tray (E),
5)
empty it and clean it.
Remove the drip tray (D), drain it and clean it.
6)
Restore the initial conditions after completing
7)
the operation.
GB
Important
The "Drain extension" accessory is used
to drain directly into a larger container or
siphon with grille.
To install the accessory proceed as follows:
Remove the collection basin.
1)
Install the extension as shown in the image
2)
here on the side.
3320070_ut_GB_rev.1

CLEANING THE BURNER

DRAIN EXTENSION INSTALLATION

- 12 -
B
A
C
D
E
ENGLISH