Backwashing The Pool Filter; Storage And Winterizing - Polaris Vac-Sweep 480 PRO Manual Del Usuario

Disposable Filter Bag
To replace disposable bag:
1. Push tabs of bag clip assembly to the open
position.
2. Disengage the alignment pin and remove the
old bag.
3. Fit cuff of disposable bag over opening. Bag
seam should face the back of the cleaner
and hole in filter bag cuff should engage with
alignment pin.
4. Close bag clip assembly to
lock in place.
In-Line Filter
The in-line filter contains a filter screen to keep
debris that is not caught by the pool filtration system
out of the Polaris.
To clean this screen, pull it out of the in-line filter,
rinse it and press it firmly back into place.

Backwashing the Pool Filter

Always disconnect the Polaris from the pool wall
before cleaning or backwashing the pool filter. After cleaning or backwashing, let the filtration system run for at
least five minutes to flush out the return lines before re-connecting the Polaris.

Storage and Winterizing

Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water (freeze damage is
not covered under the warranty). Remove the UWF from the pool wall using the UWF Removal Tool (part #10-
102-00) included with the cleaner.
Disposable Bag
Alignment Hole
Back of Cleaner
Open
www.polarispool.com
Bag Clip
in Open
Position
Alignment Pin
In-Line Filter