Frontier BG1000 Manual Del Operador página 17

OPERATING INSTRUCTIONS (Continued)
MOUNTING THE BEDKNIFE ON THE BEDKNIFE SUPPORT (Continued)
3. Adjust the position of the middle bedknife support if necessary. (See Fig 8) Use the top support
bracket to trap the bedknife against the bedknife support.
4. Use the gauge to adjust the bedknife in and out by touching the front of the center on one end,
then lift the rod, move the carriage and compare to the front of the cylinder on the other end.
Repeat! This must be checked several times because when you move one end, the other end
moves as well.
5. Use the gauge to adjust the bedknife up and down by touching the top of the center on one end,
then lift the rod, move the carriage and compare to the top of the cylinder on the other end.
Repeat! This must be checked several times because when you move one end, the other end
moves as well.
6. Loosen the two rotate lock knobs and rotate the trunnion
bar with and bedkife assembly to the manufacture
recommended bedknife angle. Use the angle gauge to
help determine the angle of the bedknife.
FIG. 10
Use this knob to adjust the
bedknife in or out to make
it travel true to the grinding
wheel.
FIG. 12
Use this knob to adjust the
bedknife up or down to make
the bedknife travel true to the
grinding wheel.
Loosen knobs at both ends of
trunion bar to rotate the bedknife.
Use the top support bracket to hold
the front of the bedknife against the
middle bedknife support. Lay it in the
gutter of the bedknife and tighten.
FIG. 11
FIG. 13
FIG. 14
FIG. 15
17