Frontier BG1000 Manual Del Operador página 28

TABLE OF CONTENTS
This machine is intended for reel mower bedknife grinding ONLY. Any use
other than this may cause personal injury and void the warranty.
To assure the quality and safety of your machine and to maintain the
warranty, you MUST use original equipment manufactures replacement
parts and have any repair work done by a qualified professional.
ALL operators of this equipment must be thoroughly trained BEFORE
operating the equipment.
Do not use compressed air to clean grinding dust from the machine. This
dust can cause personal injury as well as damage to the grinder. Machine
is for indoor use only. Do not use a power washer to clean the machine.
TABLE OF CONTENTS
Safety Instructions ................................................................................................. Page 2-6
Maintenance ......................................................................................................... Page 6
Service Data ......................................................................................................... Page 7
Assembly Instructions ............................................................................................ Page 8-9
Wiring ................................................................................................................... Page 9-10
Adjustments .......................................................................................................... Page 11
Exploded Views and parts Lists ............................................................................ Page 12-26
Before performing any maintenance procedure unplug the
unit from its power source.
DAILY MAINTENANCE BY THE OPERATOR
On a daily basis, clean the machine by wiping it off.
On a daily basis, remove all grinding grit from the traverse shafts and tooling bar area.
On a daily basis, inspect the machine for loose fasteners or components.
Contact your company's Maintenance Department if damaged or defective parts are found.
LUBRICATION
To protect the rails and vertical column, every 2-6 months coat with CRC3-36 then wipe dry.
Clean and lubricate the height adjustment screw when necessary with never-seize. This should be
done at least every 6 months.
DO NOT USE COMPRESSED AIR TO CLEAN
GRINDING DUST FROM GRINDER.
6