ClassicFlame 23EF004GRA Manual De Funcionamiento Para El Propietario página 8

THE REMOTE CONTROL FEATURES WORK SEAMLESSLY WITH THE CONTROL PANEL FEATURES.
THE REMOTE TRANSMITTER MUST BE AIMED TOWARDS THE FRONT CENTER OF THE FIREPLACE.
IF THE REMOTE TRANSMITTER IS NOT WORKING, PLEASE REPLACE THE BATTERIES WITH NEW ONES.
POWER STANDBY
The POWER STANDBY button will put the insert
in a standby mode. This will turn off all func-
tions at once but will hold the settings in mem-
ory. By pressing the button again the unit will
turn on at the same settings. This will not turn off
the MAIN POWER switch
HEAT
The HEAT button supplies power to the heater
and blower. Press the button to raise the heat set
temperature, there are five preset temperature
settings and an OFF setting. Each time the button
is pressed it will cycle to the next setting. The red
LED lights next to the button represents the cur-
rent setting. The remote control works in conjunc-
tion with the control panel.
FLAME
The FLAME button controls the flame effect. Press
the button to increase the brightness of the flames.
Each time the button is pressed it will increase the
LIGHT BULBS
This electric fireplace uses (3) three clear 120V, 40
watt, E12 socket base light bulbs (open small base,
chandelier type) For your convenience, if a bulb burns
out, it is a good idea to replace all the bulbs at the
same time. These bulbs are available at most home
centers, hardware stores or grocery stores.
1) Turn the Main Power button off.
2) If fireplace has been operating, let the unit cool at
least 2 hours.
3) Open the front glass doors, then slide the mesh
curtains to the sides.
4) Locate the 2 ember bed securing nuts on the left
and right sides of the log set. These securing nuts
are disguised as wooden embers (Figure 11). Turn
the nuts counter clockwise to loosen, remove
completely and set aside.
5) Securely grab the logs on left and right side and
lift log/emberbed assembly straight up. Once the
REMOTE CONTROL FUNCTIONS
SECTION 5: SERVICE
E-8
intensity of the flames. There are 5 brightness
levels including the "OFF" position. The red LED
lights next to the button represents the current
setting. The remote control works in conjunction
with the control panel.
NOTE: PLEASE OPERATE REMOTE TRANSMITTER AT A SLOW MEASURED PACE.
DEPRESS THE REMOTE CONTROL BUTTONS WITH AN EVEN MOTION AND
GENTLE PRESSURE. REPEATEDLY PRESSING BUTTONS IN RAPID SUCCESSION
MAY CAUSE THE TRANSMITTER TO MALFUNCTION
emberbed has cleared the support brackets and
threaded rods, bring the log/ember bed
assembly forward and out of the unit and set aside
in a safe place (figure 10).
6) Unhook light bulb spring clips from the bulbs and
unscrew the bulbs (Figure 9). After replacing the
light bulbs make sure to replace the light bulb
spring clip. Remember to replace all of the bulbs
at the same time with clear 120V, 40 watt, E12
socket base bulbs.
Figure 8
FLAME
HEAT
POWER
STANDBY
Figure 9
LIGHT BULB HOLDING SPRING
PULL
PULL