Engine Oil Maintenance; Engine Oil Specification; Checking Engine Oil - Westinghouse WH3250 Manual Del Propietário

Table 2: Maintenance Schedule - Authorized Westinghouse Service Dealer Performed
Maintenance Before Every
Item
Valve Clearance
Fuel Filter
Idle Speed

ENGINE OIL MAINTENANCE

Engine Oil Specification
1. Only use the engine oil specified in Figure 30.
2. Only use 4-stroke/cycle engine oil. NEVER USE
2-STROKE/CYCLE OIL.
Conventional 10W-30
5W-30
Figure 30 – Recommended Oil

Checking Engine Oil

NOTICE
Always maintain proper engine oil level. Failure to
maintain proper engine oil level could result in severe
damage to the engine and/or shorten the life of the
engine.
Always use the specified engine oil. Failure to use the
specified engine oil can cause accelerated wear
and/or shorten the life of the engine.
Engine oil level should be checked before every use.
1. Always operate or maintain the generator on a flat
surface.
2. Stop engine if running.
3. Let engine sit and cool for several minutes (allow
crankcase pressure to equalize).
4. With a damp rag, clean around the oil fill plug/
dipstick.
5. Remove oil fill plug/dipstick (see Figure 31).
After First 20
Hours or First
Use
Month of Use
– –
– –
– –
SAE 30
MAINTENANCE
After 50 Hours After 100 Hours
of Use or Every of Use or Every
3 Months 6 Months
–
– Check/Clean
–
Figure 31 – Oil Fill Plug/Dipstick
6. Check oil level:
When checking the engine oil, remove the oil fill
plug/dipstick and wipe it clean. Thread the oil fill
plug/dipstick all the way back in and then remove
and check the oil level on the oil fill plug/dipstick.
Acceptable Oil Level – Oil is visible on the cross-
hatches between the H and L lines on the oil fill
plug/dipstick (see Figure 32).
Low Oil – Oil is below the L line on the oil fill plug/
dipstick.
Figure 32 – Checking Oil Level
After 300 Hours
of Use or Every
Year
– Check/Adjust
–
– Check/Adjust
29