Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
44 27 30 07/13 / 10.10 /VA
Packing list: 1 Cable set
1 Socket
1 Socket retaining plate
1 Rubber grommet
1.
Disconnect the earth lead from the battery.
2.
Remove the boot bottom lining, loading edge casing, rear bumper, and the housing of the C post (left). Remove the
clamping that block the back seat rests (left), boot side casing (left) and remove both rear lights.
3.
In order to draw cable set (connection to socket) drill, in the place indicated (at the left-hand side rear body plate), a
hole of approx. Ø 6 mm in diameter. Then, enlarge the hole up to approx. Ø 25 mm in diameter. Secure the hole
drilled with appropriate anticorrosion remedy.
4.
Connect the cable set in the following way:
a) Draw end of lead bunch with metal lead ends through the place referred to in point 3 from boot outside and
through a hole by connection socket handle, assemble supplied grommet in the drilled hole,
b) Draw attached rubber socket retaining plate over the end of cable set (if necessary use anti-friction agent),
c) Disassemble the socket and connect cables according to the following assignment:
7 pin
Function
Indicator left
Fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Fog light
13 pin
Function
Indicator left
Trailer fog light
Rear fog light
Earth
Indicator right
Tail light right
Stop light
Tail light left
Reversing light
Trailer current supply
Charge line plus
Charge line earth
Not assigned
Earth (trailer)
5.
Push the socket with rubber retaining plate and screw the socket tightly onto the retaining plate using the supplied
nuts and screws:
a) Pay special attention to the right position of rubber retaining plate,
b) Put the cable set gently to avoid any folds and to secure it from possible wiping.
Electrical Set for Trailer Connection
Part no.
7-pin
Part no.
13-pin
3 Screws M5X35
3 Spring washer
3 Nuts M5
1 Sheet-metal screw
Installation instruction
Contact description
Cable colour
1
(L)
black/white
2
(54-G)
grey
3
(31)
brown
4
(R)
black/green
5
(58-R)
grey/red
6
(54)
black/red
7
(58-L)
grey/black
8
(58-b)
grey/white
Contact description
Cable colour
1
black/white
2
grey
2a
grey/white
3
brown
4
black/green
5
grey/red
6
black/red
7
grey/black
8
blue/red
9
red/blue 2,5mm
10
yellow 2,5mm
11
white/brown 2,5mm
12
13
Opel Corsa C manufactured 08.00-
Opel Corsa C manufactured 08.00-
1 Cap
1 Cap casing
1 End
1 End casing
2
2
2
10 Cable ties
1
2
6
7
3
5
4
8
Contact description in
7-pin socket
8
7
9
1
10
6
2
4
3
11
5
12
13
2a
Contact description in
13-pin socket
Publicidad
Tabla de contenido
