Brita Redi-Twist USS-334 Instrucciones De Instalación página 10

connect to auxiliary faucet
Install Redi-Twist
and Test for Leaks
1st Stage
Carbon
* Microbiological filter cartridge ALWAYS in this position
• Hold the Redi-Twist™ filter with the
label facing you.
• Insert filter up into the system head
until the two nozzles seat into the ports.
• Turn the Redi-Twist™ filter from left
to right (as you face it) until it stops.
• Turn on the cold water shut-off valve.
• Turn on the new faucet. Allow
the water to run for approximately 10
minutes.
• Check for any leaks.
• If system is leaking, turn off cold
water shut-off valve and refer to
troubleshooting guide.
10
Filters
™
Step 4
3rd Stage
2nd Stage
Micro-
Carbon
biological*
Align Arrow
1/4 turn
connect to auxiliary faucet
Filter Replacement
(every 6 months)
For FREE Filter Replacement
Reminder, go to
www.protectplus.com
Note: Place paper towels or rag under the filter
system to catch any water drips.
Note: The plastic tubing does not need to be
disconnected for general routine maintenance
and filter replacement. However, plastic tubing
may be easily disconnected. Simply turn off the
water supply to the filter system. Press in the
gray collar around the fitting while pulling the
plastic tubing out with the other hand.
• Turn the Redi-Twist™ filter right to
left (as you face it) until it releases.
Remove and discard used Redi-
Twist™ filter.
• See Step 4 for inserting new filter.
• Changing water filter on a regular
basis ensures optimum performance
of the water filtration system.
• Note date filter is installed on
cartridge tank label.
1/4 turn