Declaration Of Conformity - SMA SUNNY BOY STORAGE 2.5 Instrucciones Breves

4 Installation
Damage to the battery due to incorrect settings
The set battery parameters influence the charging behavior of the inverter. The battery can be
damaged by incorrect settings of the battery type, nominal voltage and capacity parameters.
• Set the correct battery type as well as the correct values for nominal voltage and battery
capacity when configuring.
• Ensure that the values recommended by the manufacturer are set for the battery (refer to the
technical data of the battery in the manufacturer documentation).
Risk of burns due to hot enclosure parts
Some parts of the enclosure can get hot during operation.
• Mount the inverter in such a way that it cannot be touched inadvertently during operation.
Damage to the inverter due to the use of cleaning agents
• If the inverter is dirty, clean the enclosure, the enclosure lid, the type label and the LEDs using
only clean water and a cloth.
4 Installation
Carry out the actions illustrated graphically in this document in the specified order and observe all
information.
You can find a detailed installation manual for installation and commissioning
as well as a user manual for configuration and troubleshooting at www.SMA-
Solar.com.
5 Declaration of Conformity
EC Declaration of conformity (valid until April 19, 2016)
within the scope of the EU directives
• Electromagnetic compatibility 2004/108/EC (EMC)
• Low Voltage Directive 2006/95/EC (LVD)
• Radio and telecommunications terminal equipment (R&TTE) 1999/05/EC
SMA Solar Technology AG confirms herewith that the inverters described in this document are in
compliance with the fundamental requirements and other relevant provisions of the above-
mentioned directives. The entire EC Declaration of Conformity can be found at www.SMA-
Solar.com.
4 SBS25-1VL-10-IS-xx-14
SMA Solar Technology AG
Quick Reference Guide