Laser Tools 5451 Manual De Instrucciones página 6

Introduction
Part No. 5451
Engine Timing Tool Kit
BMW | M60 | M62 Vanos
This kit has been developed to set and lock the crankshaft and camshaft
components of the BMW M60 and M62 VANOS and non VANOS V8 petrol
engine used in BMW, Range Rover and the Morgan Aero 8 vehicles.
www.eldontools.co.uk www.lasertools.co.uk
2
Instructions
VANOS equipped engines
Note: the camshaft nuts and screws
have left hand threads
• Secondary cam chain tensioners -
• When reitting the cam chains on VANOS
equipped engines BMW recommend the
use of a multi-meter set to continuity and
connected to the camshaft adjuster
contact pin and the screw on the oil line on
the cylinder head as shown on Figure 3.
Figure 3
• Using component L turn the camshaft
ixing anticlockwise using a torque wrench
set to 40Nm. Turn the pulley ixing nut until
the multi-meter buzzer sounds indicating
the camshaft adjuster is set. Now tighten
the ixing bolts of the camshaft pulley.
• Repeat for both banks.
Installing sensor gears on inlet camshafts
• Fit the sensor gear, do not tighten the
ixing nut
• Align the sensor gears as shown and
install the locking tools (I & J) as shown in
ig. 4
www.lasertools.co.uk
Figure 4
Left hand bank
Right hand bank
7