Menu Navigation - Uline OHAUS DEFENDER H-2587 Manual Del Usario

1. Remove four red shipping spacers located under
metal platform. (See Figure 1)
TURNING INDICATOR ON/OFF
1. To turn the Indicator on,
press and hold the
ON/ZERO OFF button for
two seconds. The Indicator
performs a display test, momentarily displays
the software version and then enters the active
weighing mode.
2. To turn the Indicator off,
press and hold the
ON/ZERO OFF button until
OFF
is displayed.

MENU NAVIGATION

TO ENTER THE MENU MODE
1. Press and hold the TARE MENU button until
appears on the display. The first upper level
menu appears on the display. Summary of button
navigation functions in menu mode:
YES Allows entry into the displayed menu.
Accepts the displayed setting and
advances to the next menu item.
NO Skips by the displayed menu. Rejects
the displayed setting or menu item and
advances to the next available item.
BACK Moves backwards through the upper
and middle level menus. Backs out of a
list of selectable items to the previous
middle level menu.
Exits from menu directly to the active
EXIT
weighing mode.
PAGE 2 OF 24
SET UP
OPERATION
CHANGE UNIT OF MEASURE
SET UNIT OF MEASURE AT STARTUP
Set the unit of measure displayed at startup to g, kg, lb.,
oz., lb:oz or Auto (last unit in use when power was turned off).
1. Once in the setup menu, press NO
until the Power On Unit setting is
displayed.
2. Press YES to enter the Power On Unit setting.
3. Press NO until the desired unit of measure is
displayed.
4. Press YES to accept the new unit of measure.
ENABLE UNITS OF MEASURE
Units of measure must be enabled in the menu to select
from the PRINTS/UNIT/NO button.
MENU
1. Once in the unit menu, you may turn
units of measure on and off.
(See Figure 2)
Figure 2
2. Press YES to accept the current setting (ON or OFF).
3. Press NO to change the current setting (ON or OFF).
Figure 1
Reset No, Yes
Kilograms Off, On
Pounds Off, On
Off, On
Grams
Ounces Off, On
Pounds:Ounces Off, On
End Unit
Exit UNIT menu
AUtO
UNIt
0318 IH-2587