Setup Menu - Uline H-1121 Manual Del Usuario

TO ENTER SET UP MENU
1. Turn off the scale.
2. Press and hold the ZERO key while turning on the
scale. The display will show SET SCALE FUNC.
BACKLIGHT
The backlight is provided for better visibility when the
scale is used in a dark environment.
1. Press 0 and display will show SEt0 Light OnOFF.
SEt0
2. Continue to press 0 to choose setup:
• ON: Backlight will always be ON.
• ONOFF: Backlight will be ON only when there is
something on the platform and it is greater than 9
times of the set display accuracy.
• OFF: Backlight will always be off.
• 2: Backlight stays on for 2 seconds after weight is
applied to scale.
• 5: Backlight stays on for 5 seconds after weight is
applied to scale.
• 10: Backlight stays on for 10 seconds after weight is
applied to scale.
3. Press ZERO to return back to the weighing/counting
mode.
AUTO POWER-OFF
When the auto power-off time is enabled, the scale will
automatically turn off when there has been no load on
the platform and the scale is stable at zero position for a
specific period of time (in minutes).
SEt3
1. Press 3 and the display will show SEt3 OFFt OFF.
2. Five options exist: 5, 10, 30, 60 minutes and OFF are
available.
3. Continue to press 3 to choose the desired setup.
When OFF is chosen, the Auto Power-Off feature is
not enabled and the scale will remain on.
PAGE 5 OF 18
L i9ht OnOFF
OFFt OFF
SET UP MENU
4. Press ZERO to return back to the weighing/counting mode.
MOTION FILTERING
This function is provided for weighing vibrating objects
or to prevent the scale from vibration, which will affect
the stability of the scale.
SEt2
1. Press 2 and the display will show SEt2 FiLt -1-.
2. Continue to press 2 to choose motion filtering level as 1 or 2.
• Level 1: Reaction is faster, effect to filter vibration is worse.
• Level 2: Reaction is slower, effect to filter vibration is better.
3. Press ZERO to return back to the weighing/counting mode.
TURNING CHECK COUNTING SOUNDS ON/OFF
When in the check counting mode, alarm sounds can
be enabled.
1. Press 7 and the display will show SEt7 bEEP nbEEP.
2. Continue to press 7 to choose the correct setup.
• Un:
• In:
• no:
• Lo:
• nbeep:
3. Press ZERO to return back to weighing/counting
mode.
F iLt
bEEP
Beep sounds when quantities are over
the setting of Hi.
Beep sounds when quantities are within
the setting of Hi and Lo, including the
Hi and Lo limits.
Beep sounds when quantities are out of
Hi and Lo setting.
Beep sounds when quantities are below
the setting of Lo.
No beep alert.
- 1 -
nbEEP
0421 IH-1121