Using The Pioneer Speaker Stand Cp-7Ex; Choosing Where To Place The Speaker Systems; Speaker Base; Washers - Pioneer S-8EX-W Manual Del Usuario

Using the Pioneer Speaker Stand CP-7EX

To use the CP-7EX stand, the furnished speaker base needs to be
attached to the stand stems of the CP-7EX. Assemble the stands
as shown below.
Installation
1 Remove the packing material from the countersunk
screw holes in the speaker base.
2 Attach the speaker base to the stand stems of the CP-7EX.
Use only the furnished screws (M6 x L35).
Speaker
base
Stand stems
Stand base
CP-7EX
3 Affix the non-skid pads (large).
4 Using the furnished screws (M5 x L40), spring washer and
washer, fasten the speaker to the stand.
To help ensure the speaker from falling, use only the provided
screws to fasten the speaker system to the speaker stand. For
details, consult the instructions provided with the CP-7EX
speaker stand.
Large non-skid pads

Washers

Spring washer

Screw (M5 x L40)

Screws (M6 x L35)

Choosing Where To Place The Speaker Systems

Placement within the listening room will have a great impact upon
the total performance of the S-8EX speaker system in terms of
bass performance, tonal accuracy, and imaging. All rooms are
different and so this section is intended as a guide only.
Experimentation in your room will yield optimum results.
Use the graphic below as a guide to determine optimal speaker
placement.
Front
speaker
Center speaker
Listening position
.
• Do not place the speaker where it will be in direct sunlight, and
avoid positioning it near heaters and air conditioners. Doing
so may cause warping and discoloration of the speaker
cabinet and damage to the speaker.
• Pioneer assumes no liability whatsoever for damages
resulting from assembly, improper mounting, insufficient
reinforcement, misuse of the product, acts of nature, etc.
30 cm to 60 cm
Front
speaker
7
En