Before Using The Remote Control; Replace The Battery - Pioneer XW-NAC3-K Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

01
Before you start

Before using the remote control

The battery supplied with this unit is stored in
the battery casing.
Remove the protective seal from the
battery casing.
When you notice a decrease in the operating
range, replace the battery (see below).

Replace the battery

When replacing the battery, use a
commercially available Lithium CR2025
battery.
1
While pushing the release tab, pull out
the battery casing.
2
Remove the battery from the casing.
3
Place a new battery in the casing.
Make sure the  side of the battery is facing up
when you place it in the space provided.
6
En
1
1
3
2
Caution
When using lithium batteries, please observe
the following:
• There is danger of explosion if the battery is
incorrectly replaced. Make sure to replace
only with the same or equivalent type
recommended by the manufacturer.
• Dispose of used battery cells immediately
after replacement. Keep away from
children.
• If swallowed, please contact a doctor
immediately.
• Lithium batteries may present a fire or
chemical burn hazard if misused. Do not
disassemble, heat above 100 °C, or
incinerate.
• Remove the battery if the unit isn't going to
be used for a month or more.
• When disposing of used batteries, please
comply with governmental regulations or
environmental public instruction's rules
that apply in your country or area.
• WARNING
Do not use or store batteries in direct
sunlight or other excessively hot place,
such as inside a car or near a heater. This
can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the
life or performance of batteries.

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Xw-nac3-wXw-nac3-r

Tabla de contenido