Placing The Receiver - AKG WMS40 Modo De Empleo

3 Setting Up
Important: Prior to setting up your
WMS 40, check that the transmitter
and receiver are tuned to the same
frequency. The easiest way to do this
is to compare the color codes on the
transmitter and receiver.

3.1 Placing the Receiver

Reflections off metal parts, walls, cei-
lings, etc. or the shadow effects of musi-
cians and other people may weaken or
cancel the direct transmitter signal.
For best results, place the receiver as
follows:
1. Place the receiver near the perform-
ance area (stage). Make sure, though,
that the transmitter will never get any
14
closer to the receiver than 10 ft (3 m).
Optimum separation is 16 ft. (5 m).
2. Check that you can see the receiver
from where you will be using the
transmitter.
3. Place the receiver at least 5 ft. (1.5 m)
away from any big metal objects,
walls, scaffolding, ceilings, etc.
3.2 Inserting and Testing Batteries
Refer to fig. 2)
1. Depress the snap hook on the battery
compartment lid (4).
2. Pull the battery compartment lid (4)
down to remove it from the trans-
mitter.
Important: The foam pads on the inside
of the battery compartment lid holds
the batteries in place. Do not remove
the foam pad. If you do, the batteries
will not be held in place properly and
may cause a rattling noise.
Fig. 2: Inserting the batteries.
2 x
1.5V
+
–
+
–