Fein ASCS4.8 Manual De Instrucciones página 12

OBJ_BUCH-0000000373-001.book Page 12 Thursday, February 14, 2019 1:16 PM
en
12
Assembly instructions.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Removing and charging the battery
(figure 2).
Prior to the first charging procedure, read the
operating instructions of the battery charger.
Charge the battery completely before putting
into operation for the first time.
Release the battery by pressing the battery-
unlocking button and pull the battery out of
the handle. Do not exert any force when
doing this.
Connect the battery charger to a socket out-
let, slide the battery onto the battery charger
and charge the battery. After the charging
process is over, insert the battery into the
power tool and pull the plug of the battery
charger out of the socket outlet.
A new battery does not reach its full capacity
until after several charging and discharging
procedures.
Changing the tool (figure 3).
Pull the depth stop off with a turning motion.
Push the sleeve of the tool holder toward the
front.
Insert the application tool and release the
sleeve.