Fein ASCS4.8 Manual De Instrucciones página 18

OBJ_BUCH-0000000373-001.book Page 18 Thursday, February 14, 2019 1:16 PM
en
18
Repair and customer service.
Before mounting or replacing application tools or accessories, remove the bat-
WARNING
tery. This preventive safety measure rules out the danger of injuries through
accidental starting of the power tool.
Exchangeable parts
If required, you can change the following
parts yourself: application tools, depth stop,
battery, belt clip
Service.
Have maintenance carried out
WARNING
only through qualified person-
nel. Incorrectly mounted leads and compo-
nents can cause serious injuries. Have the
required service carried out only through a
FEIN customer service agent.
Products that have come into contact with
asbestos may not be sent in for repair. Dis-
pose of products contaminated with asbestos
according to the applicable country-specific
regulations for such disposal.
The current spare parts list for this power
tool can be found in the Internet at
www.fein.com.
Warranty and liability.
The warranty for the product is valid in accordance with the legal regulations in the country
where it is marketed. In addition, FEIN also provides a guarantee in accordance with the FEIN
manufacturer's warranty declaration.
Not all accessories described or shown in this instruction manual will be included with your-
power tool.
Environmental protection, disposal.
Packaging, worn out power tools and accessories should be sorted for environmental-friendly
recycling.
Dispose of batteries only when discharged.
For batteries that are not completely discharged, insulate the terminals with tape as a protective
measure against short-circuiting.
For further information, please contact your specialist shop.
Cleaning.
Remove the battery prior to
WARNING
any maintenance and cleaning.
This preventive safety measure rules out the
danger of injuries through accidental starting
of the power tool.
When using in environments
WARNING
with conductive dust in the air,
such as when working metals, this dust can
settle in the interior of the power tool. There-
fore, regularly blow out the interior of the
power tool from outside via the ventilation
openings with dry, oil-free compressed air;
always wear eye protection when doing this.
Do not attempt to clean
CAUTION
clogged or dirty ventilation
openings of the power tool with pointed
metal objects; use nonmetal tools or objects
if necessary.
Do not use cleaning agents
CAUTION
and solvents that can cause
damage to plastic parts. These include: Gas-
oline, carbon-tetrachloride, chloric solvents,
ammonia and domestic cleaning agents that
contain ammonia.