User Instructions; How To Use - Ambiano WTF-99E-2 Manual Del Usuario

User Instructions

How to Use

1. Do not plug the slicer in until ready to use.
2. Attach the feed chute to the slicer base. This is done by holding the feed chute at
a 45 degree angle to the right, inserting it in to the socket on the slicer base, then
rotating it 45 degrees back to the left so that it is locked in to place in the upright
position. This may seem very hard to do the first few times, however the more it
is placed on and taken off, the easier it will become.
3. Select a colored cone suitable for the slicing, shredding or grating task you require
and fit it onto the star shaped drive mechanism at the back of the feed chute.
Rotate it slightly clockwise to hold it in place. WARNING: The shredding and
slicing cones are very sharp. Please handle with care.
4. Place the splash guard onto the feed chute, turning counter-clockwise to lock it
into place. Note: The splash guard must be secure in order to hold the cone in
place.
5. Prepare the fruit and vegetables before use by washing the produce before it is
used. Remove stones from cherries, peaches, nectarines, apples, etc.
6. Cut the ingredients into pieces that will fit into the feed chute, if necessary, and
place a suitable container under the splash guard.
7. Place the food upright in feed chute until it is full. Plug the power cord into and
outlet and turn the slicer on and apply pressure evenly with the food pusher.
Failure to properly load the feed chute or to apply the correct pressure may result
in the food falling over in the feed chute which will result in uneven slices and
shreds.
User instructions
9