Before Using For The First Time - TEFAL KI240D10 Manual Del Usuario

BEFORE USING FOR THE FIRST TIME

1. Remove all of the various packaging, stickers or accessories from both the inside and outside of
the kettle (do not forget to remove the transparent protective film from the screen).
2. Adjust the length of the cord by winding it under the base. Wedge the cord into the notch. (fig 1)
Throw away the water from the first two/three uses as it may contain dust. Rinse the kettle and
the filter separately.
USE
1. TO OPEN THE LID, ACCORDING TO THE MODEL
– Press on the locking system and the lid lifts automatically. (fig 2)
To close, press down firmly on the lid.
2. PLACE THE BASE ON A FLAT, STABLE, HEAT-RESISTANT SURFACE AWAY FROM WATER
SPLASHES AND ANY SOURCES OF HEAT.
• Kettle is only to be used with the base provided.
3. FILL THE KETTLE WITH THE DESIRED AMOUNT OF WATER.
• You can fill it through the spout, which ensures better maintenance of the filter.
• Never fill the kettle when it is on its base.
• Do not fill it above the maximum level, or below the minimum level. If the kettle is too full,
boiling water may spill out.
• Do not use without water.
• Check that the lid is closed properly before use.
4. POSITION THE KETTLE ON ITS BASE. PLUG IT INTO THE MAINS SOCKET.
5. TO START THE KETTLE
Press the on/off button on the base
The temperature of the water in the kettle is displayed on the screen.
TO BOIL THE WATER
2 options:
– If you would like to boil the kettle, press the
– If you would like to choose your own temperature (7 options: 100° - 95° - 90° - 85° - 80° - 70° -
60°C), press the button until you reach the desired temperature.
Once the temperature has been chosen (either with the
will begin automatically after 2 seconds, and will stop once the selected temperature has been
reached (accurate to +/- 3°C).
To stop the cycle once it is under way, press the selected button once again (either the
button).
KEEP WARM FUNCTION
Your kettle has a 'keep warm' function . If you have selected a temperature beforehand, the water
will be heated to this temperature and then kept at this temperature for 1 hour; if not then it will be
kept warm at 60°C.
The maximum permitted temperature for the Keep Warm function is 95°C.
NOTE
The screen will turn off automatically after 30 minutes (standby mode) but all the buttons will
remain active. This means that pressing any button will switch the screen back on.
If you use the button to select a temperature less than that of the water already in the kettle,
the function will not be activated and the cycle will not start.
Example: if the water is 90°C, you will not be able to start cycles for temperatures of
60°C/70°C/80°C/85°C.
.
button.
10
(fig 3)
or button), the boiling cycle
or