Cleaning And Maintenance; In The Event Of Problems - TEFAL COCOON KO3041KR Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20
Mode?le Notice COCOON 1:Mise en page 1
Never immerse the kettle,
its base, the cord or the
electric plug in water:
the electrical connections
or the switch must
not come into contact
with water.
Do not use scouring pads.
Descaling
Descale regularly, preferably at least once a month or more frequently if your
water is very hard.
To descale your kettle:
• white vinegar:
- fill the kettle with ½ l of vinegar, available from hardware stores:
- leave to stand for 1 hour without heating.
• using citric acid:
- boil ½ litre of water,
- add 25 g of citric acid and leave to stand for 15 min.
• use a descaler specifically for plastic kettles: follow the manufacturer's
instructions.
Empty your kettle and rinse 5 or 6 times. Repeat if necessary.
To descale your filter:
Soak the filter in white vinegar or diluted citric acid.
TEFAL reserves the right
to modify the characte-
ristics or components of
its kettles at any time in
the interests of the
consumer.
Do not use the kettle. No
attempt must be made
to dismantle the kettle or
its safety devices.
27/05/08

Cleaning and maintenance

CLEANING YOUR KETTLE
Unplug it.
Let it cool down and clean it with a damp sponge.
fig 5
CLEANING THE FILTER
The removable filter consists of a mesh to retain the particles of scale and
prevent them falling into your cup when pouring. This filter neither treats nor
removes the hardness of the water. It thus conserves all the qualities of the
water. With very hard water, the filter can clog very quickly (10 to 15 uses). It
is important to clean it regularly. If it is wet, put it under a running tap, if dry,
then brush it gently. Sometimes the scale will not detach itself; it will then
need descaling.
THERE IS NO EVIDENT DAMAGE TO YOUR KETTLE
• The kettle does not work or stops before coming to the boil
- Check that your kettle is properly connected.
- The kettle has been switched on without water or an accumulation
of scale has caused the overheat cut-out to operate: allow the kettle
to cool and fill it with water. Descale first if scale has accumulated.
Switch it on: the kettle should start working again after about 15 minutes.
• The water tastes of plastic:
Generally, this happens when the kettle is new, discard the water from the first
few boilings. If the problem persists, fill the kettle to maximum and add two
teaspoons of bicarbonate of soda. Bring to the boil and discard the water.
Rinse out the kettle.
13:29
Page 9
.
Never use a descaling
method other than that
recommended.

In the event of problems

GB
9

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cocoon ko304131

Tabla de contenido