Starting Operation - Bosch PSM 80 A Manual Origina

16 | English
Replacing the Sanding Sheet
(see figure C)
When attaching a new sanding sheet, remove
any dust or debris from the sanding plate 3 (e. g.
with a brush).
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
The sanding plate 3 is fitted with Velcro backing
for quick and easy fastening of sanding sheets
with Velcro adhesion.
Before attaching the sanding sheet 4, free the
Velcro backing of the sanding plate 3 from any
debris by tapping against it in order to enable
optimum adhesion.
The machine is fitted with 2 sanding sheets that
can be changed individually, depending on the
degree of wear.
Only use the machine when both sanding
sheets are mounted.
Only use sanding sheets with the same
grain size.
Position the sanding sheet 4 flush alongside one
edge of the sanding plate 3, then lay the sanding
sheet onto the sanding plate and press firmly.
To remove the sanding sheet 4, grasp it at one
of the tips and pull it off from the sanding plate
3.
Sanding sheets of the Bosch Delta Sander can
be used.
Sanding accessories, such as fleece pads/pol-
ishing cloth pads, are attached to the sanding
plate in the same manner.
2 609 004 461 | (20.1.10)
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For the working of all
wooden materials
For coarse-sanding, e. g.
of rough, unplaned
beams and boards
For face sanding and
planing small irregulari-
ties
For finish and fine sand-
ing of hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of prim-
ers before coating
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Grain size
40—180
coarse 40
medium 80, 120
fine 180
40—180
coarse 40
medium 80, 120
fine 180
Bosch Power Tools