Fein GRIT GIL Instrucciones De Uso página 11

3 94 10 007 000 - Buch Seite 11 Mittwoch, 6. September 2006 12:49 12
GIL
At a glance.
1 Protective cover, top (GI 150/GI 150 2H)
2 Spark guard (GI 150/GI 150 2H)
3 Grinding rest (GI 150/GI 150 2H)
4 Dust collector (GI 150/GI 150 2H)
5 Face- grinding rest (GI 150/GI 150 2H)
6 Plate with threads (GI 150/GI 150 2H)
7 Side cover (GI 150/GI 150 2H)
8 Crank for adjustment of work piece thickness
9 Scale for work piece thickness
10 Star-knob bolt for feed force
11 Clamping lever for guide stop
12 Guide stop
13 Cover
14 Adjustment screw for parallelism of brake
wheel
15 On/Off switch
16 Contact wheel
17 Adjustment screw for inclination of contact
wheel
18 Bolt
19 Adjustment screw for parallelism of contact
wheel
20 Brake wheel
21 Adjustment screw for alignment of grinding
rest
22 Screw
23 Fixture
24 Side cover
25 Screw for side cover
26 Fastening screws
27 Plug
28 Star-knob bolt for height-adjustment
of contact wheel
29 Clamping lever for adjustment of work piece
thickness
Intended use of the machine.
The grinding device is intended for automatic
grinding of flat work pieces with uniform feed
pressure and constant feed together with the
GI 150/GI 150 2H belt grinder.
Mounting instructions.
Before any work on the machine itself, pull
the power plug of the belt grinder from the
socket outlet.
Belt grinder GI 150/GI 150 2H:
Mount the belt grinder onto a correspond-
ing GIB/GIBE undercarriage/base unit.
Check if the belt grinder is securely fastened
(see figure 1).
Pay attention that the belt grinder is set-up/
aligned horizontally.
Dismount the following components from the
belt grinder (see figure 2):
– Top protective cover (1) with spark guard (2)
– Side cover (7)
– Grinding rest (3)
– Dust collector (4)
– Face-grinding rest (5)
– Grinding belt
– Plate with threads (6)
Grinding device GIL.
Take the device out of the packaging and
check the individual parts for completeness.
Mount the fixture (23) with one of the two
remaining screws of the plate with the
threads to the left-hand, rear drill hole of the
belt grinder. Pay attention that the thread
hole faces upwards (see figure 3).
Position the device to the left of the belt
grinder in such a manner, that the rear edges
of the belt grinder and the device are flush.
Slide the device to the right until the bolt
in the back fits the hole in the back.
Insert the bolt (21) through the drill hole.
The bolt must engage into the thread hole.
Screw the bolt (21) into the fixture (23)
until the right-hand side wall of the belt
grinder and the device are parallel to each
other. Check the parallelism with a rule.
Mount the device to the belt grinder with
the screws (26).
Check the parallelism again and correct if
required.
EN
11