Fein GRIT GIL Instrucciones De Uso página 13

3 94 10 007 000 - Buch Seite 13 Mittwoch, 6. September 2006 12:49 12
GIL
Changing the grinding belt.
Before any work on the machine itself, pull
the power plug of the belt grinder from the
socket outlet.
Lower the contact wheel (16) with the star-
knob bolt (28).
Replace the grinding belt (see GI 150 Oper-
ating Instructions).
Adjust the tracking of the belt as already
described.
Adjust the contact wheel and the brake
wheel.
Shut the protective covers.
Extraction device.
The machine can be connected via the connec-
tion sleeve to an undercarriage or base unit with
dust extraction.
Repair and customer service.
Repairs may be carried out only by quali-
fied persons in conformity with the valid
regulations.
For repairs, we recommend our FEIN customer
service centre, the FEIN authorised service cen-
tres and FEIN agencies.
Carry out the following maintenance regularly:
Blow out the ventilation slots at the motor
housing and the marked locations with
compressed air.
Lubricate the machine daily (when in use)
with machine oil at the locations marked.
Check the brake wheel and the contact
wheel for wear and damage each time when
changing the grinding belt. Have damaged
parts replaced.
Warranty and liability.
The warranty for the product is valid in accord-
ance with the legal regulations in the country
where it is marketed.
In addition, FEIN also provides a guarantee in
accordance with the FEIN manufacturer's guar-
antee. For further details on this, please contact
your specialist dealer, your national FEIN repre-
sentative, or the FEIN customer service centre.
Declaration of conformity.
The GRIT Corp. declares itself solely responsible
for this product conforming to the documents
and standards given on the last page of this
Instruction Manual.
Environmental protection, disposal.
Stationary machines should be sorted for envi-
ronment-friendly recycling in accordance with
national laws.
Noise emission values.
Measured A-weighted sound power level L
(re 1 pW), in decibels: 89
Measuring uncertainty K
wA
A-weighted emission pressure power level
measured at the workplace L
decibels: 78
Measuring uncertainty K
pA
REMARK: The sum of the measured emission
value and respective measuring inaccuracy rep-
resents the upper limit of the values that can
occur during measuring.
Wear ear protection!
For measurement values obtained according to
the respective product standard, see the last
page of this Instruction Manual.
Specifications.
Type
Reference number
7 90 2.. ..0 800 40 3
No-load speed [rpm] 1730 / 1440
Power input [W]
Voltage [V]
Frequency [Hz]
Weight according to
EPTA-Procedure
01/2003 [kg]
Class of protection
Connection diagrams.
Type GIL Appendix 87
EN
wA
, in decibels: 3
(re 20 µPa), in
pA
, in decibels: 3
GIL GIL
..0 800 40 3
1730 / 1440
180 180
3 x 400 / 3 x 230 /
3 x 400 3 x 220
50 / 60 50 / 60
64 64
I/ I/
13